Cutting and repairing implement parts in a small farm workshop

This is the discussion - forum of the Category 'Crop-Farming, Cattle-Breeding, Forestry, AgriTech'.

Here you can write messages, share your farm-experiences and answer to questions, taking part to discussions about GENERAL AGRICULTURE (crop-farming, cattle breeding).

Moderator: Moderator

AndreyK_bandsaw
Newbie
Newbie
Posts: 3
Joined: Yesterday, 7:22
Location: Москва

Cutting and repairing implement parts in a small farm workshop

Post by AndreyK_bandsaw »

When a bracket, hitch pin hole or a section of implement frame needs to be recut, a band saw is usually cleaner than an angle grinder: the cut stays square and you lose less material that later has to be filed back. For typical farm steel (mild box section, flats, the occasional harder pin) the usual mistake is running a fine wood-cutting blade, or a worn metal blade too fast, which overheats the teeth and wanders off the line. A proper metal-cutting blade, modest speed and a firm clamp make a noticeable difference, especially on thin-wall tube that a grinder likes to tear.

I found a short practical handbook on this, Metal-Cutting Band Saw Blades, published by Stankotorg.

Return to “- Questions & Debates about Crops, Cattle & AgTech”

Who is online

Users browsing this forum: Google (Desktop - 2) [Latte] and 0 guests